How do I change rear endorsing on a Panini 120e?

How do I change rear endorsing on a Panini 120e?

The font for Panini 120e is smaller than for the NCR 7780 and you may find you have to move the endorsement/audit trail over so it falls in the appropriate zone. There's a limit of maximum characters and maximum characters per line.

You can adjust the start position by setting the following Panini-specific option (SetDriverOption) in the PaniniOptions.ini file:
  1. [Endorsing]
  2. Offset=X
Where X is in some Panini-defined arbitrary increments. This represents stepper motor increments.
Ranger® - The universal check scanner interface
Copyright © 2023 Silver Bullet Technology
 www.sbullet.com

    • Related Articles

    • How can I change the image resolution for the SS Pro/Value/Adaptive?

      For Ranger for SS Pro/Value/Adaptive v2.X.X.X (CAPI): The setting below will change the bitonal and grayscale image resolution. Grayscale resolution will be half the bitonal. The option needs to be set through the Ranger driver option in ...

    • MyVision X: How do I change the horizontal offset for inkjet endorsing an item?

      You can set the offset by changing an ini value in the driver options file (MVXOptions.ini). The ini setting is in the "Inkjet" section and is called "EndorsementOffset." valid range of values is 0-180 mm. Ranger® - The universal check scanner ...

    • Problems upgrading Ranger for Panini MVX

      Note: These instructions are only for Ranger v2. If you find MultiDemo (a Panini sample application) installed on the computer this indicates that more recent Panini drivers are installed. These drivers are not compatible with Ranger v2 and must be ...

    • How do I get a Panini Log?

      Create the C:\ProgramData\Panini directory Put the file "logf.data" in there. Once that is done, logs start appearing in that directory. See also: How do I capture and send a Ranger log to technical support? Ranger® - The universal check scanner ...

    • How can the CR-190i and CR-135i use NextItem or CurrentItem endorsing?

      The CR-190i and CR-135i use Batch mode endorsing by default. They can be set to use NextItem or CurrentItem endorsing by setting up some driver options. The default driver options file is Canon-CR135iCR190i.ini By default the driver options are going ...