How do I determine the IP Address of the scanner?

How do I determine the IP Address of the scanner?

These instructions are for the CR-120/CR-150 Network-Enabled Scanners.
  1. Once the network-capable scanner is installed and any firmware updates provided by Canon for the network-capable scanner have been installed properly, connect the scanner via USB to the target system.
  2. Once the drivers have been installed, go to "Devices and Printers" on your system under Control Panel.
  3. At this point, you should see either the "CANON CR-120" or "CANON CR-150". On whichever you see, right-click and select "Scan Properties". This requires administrator privileges on the system.
  4. A "CANON [CR-120 or CR-150] USB Properties" Window should be displayed. This may take longer than expected.
  5. On the "Maintenance" tab, there will an IP Address listed.
  6. Once you have this number, you should be able to adjust settings to allow connection to the device.
Copyright © 2023 Silver Bullet Technology
 www.sbullet.com

    • Related Articles

    • How do I configure Ranger to connect to a Canon Ethernet scanner?

      These instructions are for the CR-120/CR-150 Network-Enabled Scanners. In the DriverOptions.ini for the CR-120 or CR-150 file, typically named "Canon-CR120CR150.ini", set the following option: [EthernetConfig] ScannerIpAddress=XXX.XXX.XXX.XX Where ...

    • How can I determine if I found a Ranger bug?

      Your application uses the Ranger software. Ranger uses the scanner manufacturer's scanner interface software. You can determine the source of most problems by running the appropriate diagnostic application for each of these software components. ...

    • How do you start Ranger for IP Simulator?

      IP Simulator is used for testing. To start using IP Simulator: Download the latest installer for Ranger for IP Simulator from our website. You'll need login credentials. Start "IPSimulatorForRanger.exe" at 'C:\Program Files (x86)\Silver Bullet ...

    • Does IP Simulator for WiseIP work in Windows 7?

      IP Simulator v4.1.0 has been updated to work in Windows 7. Some of the supported scanners do not support Windows 7 so please refer to the table below for more information on a specific scanner. If you have any questions please contact us at ...

    • Can your provide an overview how the IP Simulator software is used?

      Please see attached pdf file for a comparison and notes on the use of Ranger for IP Simulator, IP Simulator for WiseIP and Ranger for WiseIP. IP simulator - The NCR sorter simulator Copyright © 2023 Silver Bullet Technology www.sbullet.com