MyVision X: How do I change the horizontal offset for inkjet endorsing an item?

MyVision X: How do I change the horizontal offset for inkjet endorsing an item?

You can set the offset by changing an ini value in the driver options file (MVXOptions.ini).

The ini setting is in the "Inkjet" section and is called "EndorsementOffset." valid range of values is 0-180 mm.
Ranger® - The universal check scanner interface
Copyright © 2023 Silver Bullet Technology
 www.sbullet.com

    • Related Articles

    • How do I change rear endorsing on a Panini 120e?

      The font for Panini 120e is smaller than for the NCR 7780 and you may find you have to move the endorsement/audit trail over so it falls in the appropriate zone. There's a limit of maximum characters and maximum characters per line. You can adjust ...

    • Is Ranger for MyVision X compatible with Windows 98?

      No, the Panini device drivers for the MyVision X do not work with Windows 98. Ranger® - The universal check scanner interface Copyright © 2023 Silver Bullet Technology www.sbullet.com

    • Ranger compatibility with the Vision X serial number change announced 05/24/2011

      Compatibility with the Vision X serial number changes announced today, 05/24/2011, requires Panini Vision X API version 2.41.1.4 or newer. To ensure the installation meets the above requirement, Ranger for MVX / VX version 2.2.100 or newer (higher) ...

    • How can I change the image resolution for the SS Pro/Value/Adaptive?

      For Ranger for SS Pro/Value/Adaptive v2.X.X.X (CAPI): The setting below will change the bitonal and grayscale image resolution. Grayscale resolution will be half the bitonal. The option needs to be set through the Ranger driver option in ...

    • I'm Missing Item Data

      If you've recently switched to using the CR-120 or the CR-150 from another scanner and seem to be experiencing loss of item data, please make a review of your source code during TransportNewItem, TransportSetItemOutput, and TransportItemInPocket. ...