What causes "An error occurred during the move data process: -119?"

What causes "An error occurred during the move data process: -119?"

If you're seeing a message box stating "An error occurred during the move data process: -119," and referencing LTOCX12N.OCX, it's likely that LeadTools is installed and causing a conflict.

Solution: Use an updated Ranger install (version 1.4.21.3 or later). Contact your Canon dealer or update the firmware.
Ranger® - The universal check scanner interface
Copyright © 2023 Silver Bullet Technology
 www.sbullet.com

    • Related Articles

    • I'm Missing Item Data

      If you've recently switched to using the CR-120 or the CR-150 from another scanner and seem to be experiencing loss of item data, please make a review of your source code during TransportNewItem, TransportSetItemOutput, and TransportItemInPocket. ...

    • What causes a "TC: Licensing of Features is absent" error?

      Newer versions (after v4.x) NCR's WiseIP software require a NCR dongle. IP simulator - The NCR sorter simulator Copyright © 2023 Silver Bullet Technology www.sbullet.com

    • What causes a "TC: Device Model ID not found" error?

      Computer Problem The Computer has a problem Code:FFFF4002 TC:Device Model ID not found [3111] Contact you systems analyst If you see this, or a similar message, it's likely that your version of WiseIP (for the 7780 or iTRAN) does not match the ...

    • Why am I receiving a "image compression error" on my MVX?

      There are a few reasons that your MVX scanner would indicate a "image compression error": Your PC may be performing too slow to process all of the images sent from the scanner. Panini reports: MVX API version 2.26.1.3 was able to reduce compression ...

    • What is the plug-in certification process?

      Since our certification process is evolving, we will not charge you for the first certification. There are the high-level certification steps: Send us a scanner to test with. Email us your plug-in some source code and TransportInfo.ini and ...