Why am I receiving a message that my dongle is not found?
IP Simulator v4.1.0 has been updated to correct this issue. I recommend
uninstalling the current IP Simulator and then installing the current
release.
Download page for IP Simulator v4.1.0
http://sbullet.com/download/ip-simulator-wiseip
http://sbullet.com/download/ip-simulator-wiseip
Related Articles
What causes a "TC: Device Model ID not found" error?
Computer Problem The Computer has a problem Code:FFFF4002 TC:Device Model ID not found [3111] Contact you systems analyst If you see this, or a similar message, it's likely that your version of WiseIP (for the 7780 or iTRAN) does not match the ...What causes "The software license does not support this version of Ranger" message?
"The software license does not support this version of Ranger.License: versionA <> Ranger: versionB" Ranger displays this message when: The version number of the software license key does not match Ranger's version. The "purchased software ...How can I determine if I found a Ranger bug?
Your application uses the Ranger software. Ranger uses the scanner manufacturer's scanner interface software. You can determine the source of most problems by running the appropriate diagnostic application for each of these software components. ...Why am I receiving "error: SetGenericOption() Error: The device is not ready"?
You might consider placing the ini files in common folders which are configured to allow a WRITE access to all users. Leaving the ini files in the default location or in the same folder as the Ranger DLL or OCX, may be feasible as well as long as the ...Why am I receiving a "image compression error" on my MVX?
There are a few reasons that your MVX scanner would indicate a "image compression error": Your PC may be performing too slow to process all of the images sent from the scanner. Panini reports: MVX API version 2.26.1.3 was able to reduce compression ...