Why are the versions of Ranger on Canon's website and www.sbullet.com different?

Why are the versions of Ranger on Canon's website and www.sbullet.com different?

Canon goes through their own QA software procedure before posting drivers to their website.

The version of Ranger on Canon's website is going to be the latest version that has been tested by Canon.

The version on www.sbullet.com may be more recent as it has been tested and certified by Silver Bullet, but not yet verified and quality assured by Canon.

Either version can be used, but if you encounter a problem while using the version from Canon's site, it may have been corrected in the version on www.sbullet.com.

Ranger® - The universal check scanner interface
Copyright © 2023 Silver Bullet Technology
 www.sbullet.com

    • Related Articles

    • Can I have two versions of Ranger installed on the same pc?

      Yes. The installation of two or more versions of Ranger for different transports on the same PC will not cause any conflicts between the versions. Please note though that the Ranger installer registers the Ranger control for the transport being ...

    • Why am I having problems after updating Ranger for Canon CR-180?

      Normally Ranger upgrades install and function without any problems. However, we have encountered a few situations where the following steps can be used when the CR-180 does not function after a Ranger/Canon software upgrade. We recommend completely ...

    • How can I print endorsement text with old versions of RangerFlex?

      Some older versions of RangerFlex (pre-v3.0) did not provide a means to set endorsement text via the user interface. However, you can set the endorsement text manually by editing Ranger's CapiOptions.ini file. Add the following section to the ...

    • Does my older Canon CR-180 support PC sorting?

      Newer versions of the Canon CR-180 allow the application to make pocket decisions on a per-item basis using Ranger's SetTargetLogicalPocket() call. Although visually the older and newer models appear very similar, there are significant mechanical ...

    • How do I configure Ranger to connect to a Canon Ethernet scanner?

      These instructions are for the CR-120/CR-150 Network-Enabled Scanners. In the DriverOptions.ini for the CR-120 or CR-150 file, typically named "Canon-CR120CR150.ini", set the following option: [EthernetConfig] ScannerIpAddress=XXX.XXX.XXX.XX Where ...