How do I power cycle a Canon transport?

How do I power cycle a Canon transport?

Sometimes Canon transports will deny connections. The is usually caused by the following:
  • an application closed without shutting down its connection to the scanner properly
  • an unrecoverable error occurs
If rebooting the workstation is insufficient to allow a connection, following steps will reset the scanner:
  1. Close all scanning applications.
  2. Power down the scanner.
  3. Disconnect the scanner from the workstation.
  4. Disconnect the scanner from its power supply (preferably for at least 30 seconds).
  5. Restart the workstation.
  6. Reconnect the scanner to its power supply and turn on.
  7. Wait for the scanner to run through its power up cycle.
  8. Reconnect the scanner to the workstation.
Ranger® - The universal check scanner interface
Copyright © 2023 Silver Bullet Technology
 www.sbullet.com



    • Related Articles

    • Where can I find the latest Canon CR-180 device drivers and software?

      The latest Canon CR-180 software and drivers can be found at: https://www.usa.canon.com/support/p/imageformula-cr-180-check-transport Ranger® - The universal check scanner interface Copyright © 2023 Silver Bullet Technology www.sbullet.com

    • How do I turn-off CR-180 logging to the Canon.log file?

      To disable logging to the Canon.log file: Ensure you are using Ranger for CR-180 v1.5.0.3 or newer (available here https://www.usa.canon.com/support/p/imageformula-cr-180-check-transport) Disable Canon driver support for Canon.LOG by ensuring that ...

    • Why am I having problems after updating Ranger for Canon CR-180?

      Normally Ranger upgrades install and function without any problems. However, we have encountered a few situations where the following steps can be used when the CR-180 does not function after a Ranger/Canon software upgrade. We recommend completely ...

    • How does double-feed detection work on the Canon CR-180?

      According to Canon USA, all 4 generations of the CR-180 support double feed detection. The expected behavior for a generation 1, 2, or 3 CR-180, which do not have LED sensors, is the same as a generation 4 transport with LED sensors for double feed ...

    • How do I get a Canon Log?

      Important: The method of enabling Canon logging has changed for the CR-120/150. See the below link for instructions on enabling logging for the CR-120/150 Canon check scanners. How do I capture Canon logs on the CR-120/150? To capture a Canon log on ...