How do I configure Ranger to connect to a Canon Ethernet scanner?
These instructions are for the CR-120/CR-150 Network-Enabled Scanners.
In the DriverOptions.ini for the CR-120 or CR-150 file, typically named "Canon-CR120CR150.ini", set the following option:
In the DriverOptions.ini for the CR-120 or CR-150 file, typically named "Canon-CR120CR150.ini", set the following option:
- [EthernetConfig]
- ScannerIpAddress=XXX.XXX.XXX.XX
Where the X's are the Scanner's IP address.
Related Articles
How can I connect my MagTek Excella to Ranger through Ethernet?
To connect your MagTek Excella to Ranger through Ethernet, you'll need to set up the MagTek Excella for ethernet connection. Please ensure that the MagTek Excella is connected by ethernet to the same network as the PC. In the document linked below, ...How do I determine the IP Address of the scanner?
These instructions are for the CR-120/CR-150 Network-Enabled Scanners. Once the network-capable scanner is installed and any firmware updates provided by Canon for the network-capable scanner have been installed properly, connect the scanner via USB ...Windows 7 - Scanner Compatibility List
Windows 7 support NOTE: Ranger code supports this OS. Manufacturer support is noted below. Make Model 32-bit 64-bit Notes BancTec EasyScan No No Scanner is discontinued. No planned support. Canon CR-190i Yes Yes OS support released in Ranger ...Why is my Excella scanner reporting “TranportIsDead” in Ranger?
Please make sure that you have run the "ExcellaUsbConfig" application. This application can be found in [Start->All Programs->Silver Bullet Technology->Ranger for Excella->ExcellaUsbConfig]. Select "Refresh Network Connections" Select "Search" Note ...Why am I having problems after updating Ranger for Canon CR-180?
Normally Ranger upgrades install and function without any problems. However, we have encountered a few situations where the following steps can be used when the CR-180 does not function after a Ranger/Canon software upgrade. We recommend completely ...